ISO INTERNATIONAL STANDARD 1005-6 Second edition 1994-08-01 Railway rolling stock material - Part 6: Solid wheels for tractive and trailing stock - Technical delivery conditions Materiel roulant de chemin de fer - Partie 6: Roues monoblocs pour le materiel moteur et pour le matériel remorqué -Conditions techniques de livraison Reference number ISO 1005-6:1994(E) No reproduction or networking permitted without license from IHS Not for Resale ISO 1005-6:1994(E) Contents Page Scope 2 Normative references 3 Information to be supplied by the purchaser 2 4 Classification 3 4.1 Grades of steel 3 4.2 Types of heat-treatment condition on delivery 4.3 Testing category 3 4.4 Degree of finish 3 4.5 Tolerance category Requirements 3 5.1 Chemical composition 3 5.2 Mechanical properties 3 5.3 Appearance and soundness 3 5.4 Machining allowances and dimensional tolerances . 5.5 Residual imbalance 5.6 Marking 4 6 Manufacture 6.1 Steelmaking process . 6.2 Manufacturing process 6 6.3 Removal of defective sections 6 6.4 Identificationof thewheelsduringmanufacture 6 6.5 Heat treatment 6 6.6 Machining and correction of imbaiance 6 6.7 Removal of surface defects 6.8 Shot peening CISO1994 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced orutilized in anyformorbyanymeans,electronic or mechanical, includingphotocopying and microfilm, without permission in writing from the publisher. International OrganizationforStandardization Case Postale 56 : CH-1211 Geneve 20 : Switzerland Printed in Switzerland Copyright International Organization for Standardizatio No reprodu ted without lice from IHS Not for Resale oISO ISO 1005-6:1994(E) 7 Inspection 7.1 Responsibilities and type of inspection 7.2 Inspection of manufacture 7.3 Inspection of the characteristics of the wheels 7.4 Submission for inspection by the purchaser 8 7.5 Certification B 7.6 Number of checks and tests 9 7.7 Sampling and preparation of samples and test pieces 7.8 Test methods 11 7.9 Retests 12 7.10 Conclusion of the inspection 12 8 Delivery 12 8.1 Protection against corrosion during transport 12 8.2 Protection against mechanical damage during transport 12 Annexes A Procedure for shot peening web surfaces of wheels 17 Bibliography B ili Copyright Int Standardizatior No reproduction or networking permitted without license from IHS Not for Resale